Welcome Guest [Log In] [Register]
clubae111.com is the largest community forum of English speaking AE111 owners on the internet today with over 2000 members plus a wealth of information and resources relating to the AE111 chassis and 4A-GE engines.

Join our community today!

If you're already a member please log in to your account to access all of our features:

Username:   Password:
Add Reply
Apexi Rsm; Q&A's
Topic Started: Dec 10 2008, 05:43 PM (1,506 Views)
qwertydog
Member Avatar
Stage 2
Took my car on the track the other day, and it topped out at 200kph with the speed cut on the RSM set to Off?
I'm guessing i've wired it up wrong but stumped as to why it got to 200kph before cutting out, has anyone else had a similar problem?
Offline Profile Quote Post Goto Top
 
1i1
Member Avatar
NZ Toyota Parts Guy

yup, think when it's "off" the speed cut removale function isn't on. You need to select 190km/h. I haven't had the oportunity to do this and test it though
Offline Profile Quote Post Goto Top
 
Bryan BZ-R
Member Avatar
Stage 6
Ive an rsm and its still limiting :/
Offline Profile Quote Post Goto Top
 
robcam
Member Avatar
96BZR

Bryan BZ-R
Oct 3 2010, 09:09 AM
Ive an rsm and its still limiting :/
did you wire it in correctly? there are two methods for wiring it in. One where you cut the speed feed wire to the ecu and one where you don't.
Offline Profile Quote Post Goto Top
 
Bryan BZ-R
Member Avatar
Stage 6
Yea i did it myself think its correct i toke it of the apexi site and i cut the speed wire
Offline Profile Quote Post Goto Top
 
Bryan BZ-R
Member Avatar
Stage 6
So its diagram 5T-b?
Offline Profile Quote Post Goto Top
 
1i1
Member Avatar
NZ Toyota Parts Guy

Going off this: http://www.apexi-usa.com/content/pdf6139.pdf

ECU pin out T5-A
Offline Profile Quote Post Goto Top
 
Bryan BZ-R
Member Avatar
Stage 6
Is that to remove speed cut? im so lost lol
Offline Profile Quote Post Goto Top
 
Gtturbokid
Stage 3
anybody have a tutorial for this? the apexi site is down for the instructions
Offline Profile Quote Post Goto Top
 
Ikenty
Member Avatar
BZ Touring Carib
check the link.

http://www.apexi.co.jp/products/electronics/pdf/rsm_tori_e.pdf
Offline Profile Quote Post Goto Top
 
20vees
Member Avatar
Stage 4
in advice if the speedo needle hits the dash it will break it on you disconnect it first..then make sure you have the right wire cut for the speed signal ...as far as i can remember you run the speed signal into the rsm and back out and join it back to the speed wire that was cut to make the loop..
think the wires for speed cut was pink and purple
Offline Profile Quote Post Goto Top
 
1 user reading this topic (1 Guest and 0 Anonymous)
« Previous Topic · ECU / Electronics · Next Topic »
Add Reply